Trouble with 12V Relay attached to Pump - Arduino MEGA2560 - Project Guidance - Arduino Forum

I have attached to my Arduino a 2 Channel 12V Relay. Currently the red light on the Relay is working as my program switches LOW and HIGH every 5 seconds, so I know it's communicating. My 12VDC/AC power supply is plugged in the + is spliced in through the orange wire connected to the COM2. On the NO2 I have the +(pos) going to the pump. The -(neg) of the pump is connected to the power supplies -(neg). For some reason I get no response from the NO2 switching on or off. When the red light on the

Automatic Plant Watering System using Arduino - The Engineering Projects

Using 4 relay module with arduino nano - Project Guidance - Arduino Forum, carte relais arduino

Can't turn on 12v relay with output pins - General Electronics - Arduino Forum

Problems using relay - Project Guidance - Arduino Forum

How a Relay Module Works and Interfacing a Single Channel Relay Module with Arduino

Advanced View Arduino Projects List Part 2 -Use Arduino for Projects by WiseNaeem - Issuu

Relay freezes arduino - Project Guidance - Arduino Forum

Water Pump and 5V Relay Problem Arduino - Displays - Arduino Forum

12v Relay issue - Hardware - Arduino Forum

Can an Arduino use a 12 V relay? - Electrical Engineering Stack Exchange

DIY: Relay Switch Motor Controller - Arduino : 4 Steps (with Pictures) - Instructables